Contact with us

Electronic repair
&renovation
company

Lorem ipsum
dolor mit samet

Curabitur sed iaculis dolor, non congue ligula. Maecenas imperdiet ante eget hendrerit posuere. Nunc urna libero, congue porta nibh a, semper feugiat sem. Sed auctor dui eleifend, scelerisque eros ut, pellentesque nibh.

Opening hours

Fusce ut velit laoreet, tempus arcu eu, molestie tortor.

Monday - Saturday8⁰⁰ - 20⁰⁰
Sunday8⁰⁰ - 16⁰⁰

Contact us

Aliquam ac dui vel dui vulputate consectetur. Mauris accumsan.

Maecenas sit amet molestie leo. Morbi vitae urna mauris.

Autotransformer

An autotransformer has a single winding with two end terminals and one or more terminals at intermediate tap points. It is a transformer in which the primary and secondary coils have part of their turns in common. The portion of the winding shared by both the primary and secondary is the common section. Autotransformers have no galvanic isolation!

Isolation Transformer

An isolation transformer is a transformer used to transfer electrical power from a source of alternating current (AC) power to some equipment or device while isolating the powered device from the power source, usually for safety reasons (or to reduce transients and harmonics). Isolation transformers provide galvanic isolation. Therefore no conductive path is present between the source and the load.

Toroidal Transformer

A toroidal transformer is an electrical transformer constructed with a torus or donut-shaped core. Its primary and secondary windings are wound across the entire surface of the torus core, separated by an insulating material. This configuration minimizes the magnetic flux leakage. All Ascend Electronics toroidal transformers are constructed as isolation transformers.

Air-Core Transformers

Air-core transformers are designed to transfer energy or radio-frequency currents (currents used for radio transmission). Air-core transformers consist of two or more coils wound around a solid insulating substance or on an insulating coil form and have no magnetic core. Therefore, air-core transformers have a weak energy transmission ratio.

Transformer Design Expressions

Transformer Efficiency

The ratio of a transformer's output power to its input power is known as transformer efficiency. The effect of transformer losses is measured by transformer efficiency, typically expressed as a percentage.

Transformer Voltage Regulation

Transformer voltage regulation is the ratio or percentage value by which a transformer's output terminal voltage varies either up or down from its no-load value due to variations in the connected load current.

Ambient Operating Temperature

The ambient temperature is the temperature at a location not affected by the heat generated by the transformer itself.

Transformer Temperature Rise

Transformer temperature rise is defined as the average temperature rise of the windings above the ambient (surrounding) temperature when the transformer is loaded at its nameplate rating.

High Voltage Isolation Class

The high-voltage isolation class is used during the transformers' high-pot tests. High-pot (High Potential) tests, also known as dielectric withstand tests, are used to apply high voltage to assets to determine the adequacy of the electrical insulation to withstand voltage transients and ensure the insulation is not marginal. In addition, the voltage class is used to define high-voltage potential differential operation between primary and secondary.

Input Waveforms

The transformer induces power or signal voltage waveforms for each secondary output. The resulting output waveform will be the same shape and frequency as its input waveform. Note that all transformers have bandpass characteristics, meaning they have a low-end and high-end frequency roll-off. Therefore for transformers outside the standard AC power line (50Hz to 400Hz), such as audio (20Hz-20kHz) and switching (1kHz to 10MHz), the minimum and maximum frequency of the bandwidth must be specified, in addition to the input waveform, such as pulse (square) or sinus.

WELCOME TO

ASCEND ELECTRONICS®

UNDER CONSTRUCTION

The page is temporary not available. Will be up soon.

Electronic repair
&renovation
company

Lorem ipsum
dolor mit samet

Opening hours

Contact us

My Credentials and Contact Information

Check that you are not a robot

AUTO TRANSFORMERS

Autotransformer

TRANSFORMER TYPES

Isolation Transformer

Isolation Transformer

Toroidal Transformer

Toroidal Transformer

Air-Core Transformers

Air-Core Transformers

Transformer Design Expressions

Transformer Efficiency

Transformer Efficiency

Voltage Regulation

Transformer Voltage Regulation

Ambient Operating Temperature

Ambient Operating Temperature

Transformer Temperature Rise

Transformer Temperature Rise

High Voltage Isolation Class

High Voltage Isolation Class

Input Waveforms

Input Waveforms

Electronic repair &renovation company

Lorem ipsum dolor mit samet

Opening hours

Contact us

My Credentials and Contact Information

Check that you are not a robot

AUTO TRANSFORMERS

Autotransformer

TRANSFORMER TYPES

Isolation Transformer

Isolation Transformer

Toroidal Transformer

Toroidal Transformer

Air-Core Transformers

Air-Core Transformers

Transformer Design Expressions

Transformer Efficiency

Transformer Efficiency

Voltage Regulation

Transformer Voltage Regulation

Ambient Operating Temperature

Ambient Operating Temperature

Transformer Temperature Rise

Transformer Temperature Rise

High Voltage Isolation Class

High Voltage Isolation Class

Input Waveforms

Input Waveforms

Electronic repair
&renovation
company

Lorem ipsum
dolor mit samet